Heat pumps in Brighton and Hove: cost + BUS grant

What the EPC data shows for Brighton and Hove

We’ve aggregated the current Energy Performance Certificate band for 5,000 properties in Brighton and Hove, drawn live from the GOV.UK EPC Register. The median home in our sample sits at band C, with 54% falling into band C and 33% in band D. Around 40% of homes are at band D or below — the cohort with the most realistic retrofit upside.

Does the Boiler Upgrade Scheme apply in Brighton and Hove?

Yes. Brighton and Hove is in England, where the Boiler Upgrade Scheme (BUS) pays £7,500 toward an air-source heat pump install. The grant is administered by Ofgem and deducted by the installer at the point of invoice — you never see the cash. To qualify, the property must be owner-occupied or privately rented, have a valid EPC issued in the last 10 years, and have no outstanding loft-or-cavity insulation recommendation on the EPC (unless an exemption is documented). In our sample of Brighton and Hove EPCs the median rating is band C, which means most homes need to clear at least one insulation recommendation before the installer can claim the grant.

Typical install cost in Brighton and Hove

Pre-grant install costs in Brighton and Hove typically run £8,000 to £14,000 for a 5–10 kW air-source unit, in line with UK averages — labour rates in South East sit close to the national mean. After the £7,500 BUS deduction most Brighton and Hovehomeowners pay £1,500 to £6,500 out of pocket. The figure within that range that applies to your property depends on three things: heat-loss sizing (set by floor area, fabric and air-tightness), radiator upgrades (most pre-2000s homes need at least one or two changed), and hot-water cylinder provision. An MCS-certified engineer issues the binding quote after a heat-loss calculation per BS EN 12831.

What this means for your home

Whether a heat pump is a good fit for your specific home in Brighton and Hovedepends on three factors the EPC alone can’t answer: roof + outdoor space for the external unit, radiator sizing throughout the heating circuit, and your current heating fuel + tariff. Propertoasty’s free pre-survey check combines your address, an EPC pull, the Google Solar API’s roof data, and a floorplan vision analysis to produce an installer-ready report — typically takes about five minutes.

Run a free pre-survey check on your home — installer-ready report, BUS-eligibility verdict, sizing range, and a list of MCS-certified installers covering Brighton and Hove.

How Brighton and Hove compares

Compared with the England + Wales average band-D share of roughly 45%, Brighton and Hove’s 33% sits below the national midpoint. Bands E and worse — typical pre-1930s homes without significant retrofit — make up 7% of the local sample, which compares to the E&W average of around 22%.

Nearby areas we cover

Adjacent local-authority and postcode areas — useful for comparing across a wider region:

• Heat pumps in Portsmouth — local authority
• Heat pumps in Tower Hamlets — local authority
• Heat pumps in Camden — local authority
• Heat pumps in Hackney — local authority
• Heat pumps in Slough — local authority
• Heat pumps in Southampton — local authority
• Heat pumps in Reading — local authority
• Heat pumps in Luton — local authority
• Heat pumps in Bournemouth, Christchurch and Poole — local authority
• Heat pumps in Oxford — local authority