Heat pumps in Kingston upon Hull, City of: cost + BUS grant

What the EPC data shows for Kingston upon Hull, City of

We’ve aggregated the current Energy Performance Certificate band for 5,000 properties in Kingston upon Hull, City of, drawn live from the GOV.UK EPC Register. The median home in our sample sits at band C, with 59% falling into band C and 33% in band D. Around 36% of homes are at band D or below — the cohort with the most realistic retrofit upside.

Does the Boiler Upgrade Scheme apply in Kingston upon Hull, City of?

Yes. Kingston upon Hull, City of is in England, where the Boiler Upgrade Scheme (BUS) pays £7,500 toward an air-source heat pump install. The grant is administered by Ofgem and deducted by the installer at the point of invoice — you never see the cash. To qualify, the property must be owner-occupied or privately rented, have a valid EPC issued in the last 10 years, and have no outstanding loft-or-cavity insulation recommendation on the EPC (unless an exemption is documented). In our sample of Kingston upon Hull, City of EPCs the median rating is band C, which means most homes need to clear at least one insulation recommendation before the installer can claim the grant.

Typical install cost in Kingston upon Hull, City of

Pre-grant install costs in Kingston upon Hull, City of typically run £8,000 to £14,000 for a 5–10 kW air-source unit, in line with UK averages — labour rates in Yorkshire and the Humber sit close to the national mean. After the £7,500 BUS deduction most Kingston upon Hull, City ofhomeowners pay £1,500 to £6,500 out of pocket. The figure within that range that applies to your property depends on three things: heat-loss sizing (set by floor area, fabric and air-tightness), radiator upgrades (most pre-2000s homes need at least one or two changed), and hot-water cylinder provision. An MCS-certified engineer issues the binding quote after a heat-loss calculation per BS EN 12831.

What this means for your home

Whether a heat pump is a good fit for your specific home in Kingston upon Hull, City ofdepends on three factors the EPC alone can’t answer: roof + outdoor space for the external unit, radiator sizing throughout the heating circuit, and your current heating fuel + tariff. Propertoasty’s free pre-survey check combines your address, an EPC pull, the Google Solar API’s roof data, and a floorplan vision analysis to produce an installer-ready report — typically takes about five minutes.

Run a free pre-survey check on your home — installer-ready report, BUS-eligibility verdict, sizing range, and a list of MCS-certified installers covering Kingston upon Hull, City of.

How Kingston upon Hull, City of compares

Compared with the England + Wales average band-D share of roughly 45%, Kingston upon Hull, City of’s 33% sits below the national midpoint. Bands E and worse — typical pre-1930s homes without significant retrofit — make up 3% of the local sample, which compares to the E&W average of around 22%.

Nearby areas we cover

Adjacent local-authority and postcode areas — useful for comparing across a wider region:

• Heat pumps in York — local authority
• Heat pumps in Doncaster — local authority
• Heat pumps in Wakefield — local authority
• Heat pumps in Leeds — local authority
• Heat pumps in Sheffield — local authority
• Heat pumps in Bradford — local authority
• Heat pumps in Nottingham — local authority
• Heat pumps in Middlesbrough — local authority
• Heat pumps in Oldham — local authority
• Heat pumps in Derby — local authority